.png)
| 1 | 12-24 V DC Power Supply |
| 2 | Ethernet Port with PoE |
| 3 | DALI Bus |
| 4 | KNX TP Bus |
| 5 | LED Indicator |
| 6 | Button |
¶ LED codes
Atios KNX Bridge communicates through LED signals. Here's how to read them:
| Blinking | Ready for Reboot, Release Button for Action | |
| Solid | Booting | |
| Blinking | Establish IP Connection | |
| Solid | Got IP Address | |
| Blinking | HomeKit / Matter: Pairing Mode Active | |
| Solid | Safe Mode | |
| Blinking | Keep Pressed Until Factory Reset | |
| Solid | Ready for Factory Reset, Release Button for Action | |
| Blinking | Access Point Mode Active (Wifi) | |
| Solid | Client Connected to AP | |
| Blinking | Network Disconnected | |
| Solid | KNX Programming Mode Active | |
| Blinking | Downloading and Installing Update |
¶ Button functions
There are 3 button functions that you can perform:
| 2s Press | Press and Release after 2s for Reboot |
| 10s Press | Press and Release after 10s for Factory Reset LED constant purple |
| Double Press | Quick Double Press for KNX Programming Mode LED solid red |
| Long Press During Boot |
To enter safe mode, keep pressed during reboot until steady yellow light (Device will not load user config and not start Matter / HomeKit Server) |