Button Functions & LED Codes
KNX Remote Access runs on the Atios ADE-KD hardware, a DIN-rail device. Its connections, buttons, and LEDs are shown below. For KNX Remote Access, the relevant controls are the Reset Button and the Power LED.
Reset Button functions
| Action | Description |
|---|---|
| 2s Press | Reboot: Press and release for reboot. Save your configuration beforehand and it will stay on the device, no export necessary. |
| 10s Press | Factory Reset: Hold the button until the LED blinks purple, then release to factory reset. A factory reset will delete all your KNX configuration. This cannot be undone. Export your configuration first if you want to back it up (use Export under Configuration in System Settings). |
| Double Press | KNX Programming Mode: Quick double press for KNX Programming Mode (LED solid red) |
| Long Press During Boot | Safe mode: Keep pressed during reboot until steady yellow light to enter safe mode |
Power LED codes
| LED | State | Meaning |
|---|---|---|
| 🔵 | Blinking | Ready for reboot, release button for action |
| 🔵 | Solid | Booting |
| 🟢 | Blinking | Establishing IP connection |
| 🟢 | Solid | Got IP address |
| 🟡 | Solid | Safe mode |
| 🟣 | Blinking | Ready for reset, release button for action |
| 🟣 | Solid | Device is resetting |
| ⚪ | Blinking | Access point mode active (WiFi) |
| ⚪ | Solid | Client connected to AP |
| 🔴 | Blinking | Network disconnected |
| 🔴 | Solid | KNX Programming Mode active |
| 🟠 | Blinking | Downloading and installing update |