Garage

Garage-door opener with an impulse output and at least one contact sensor for state feedback. Labelled Garage in the Web Interface.

Setup

Field	Description
Sensors	At least one is required. The input modal asks Close or Open instead of Switch / Momentary, depending on what your reed contact signals when the door is in that position.
Outputs	Pick Single relay control (one impulse output that triggers the opener) or One relay for open, another for close (two separate impulse outputs).
Runtime	Total open or close time in seconds. The SmartCore uses this together with the sensors to compute current state.
Garage has a stop state	Check this if your opener cycles OPENING, STOPPED, CLOSING with each impulse instead of just OPEN and CLOSED.

Sensor input modal

Setting	Description
Close	Pick this if your reed contact reports an active signal when the door is closed.
Open	Pick this if your reed contact reports an active signal when the door is open.
Inverted	Reverses the above reading. Use if the sensor reports the opposite of what you expect.